After a leak, the surfaces dry fast while the structure stays wet. Framing, subfloors, and wall cavities hold moisture you cannot see. Structural drying uses measured airflow and dehumidification to bring those materials back to normal moisture levels.
One free call connects you with an independent local specialist. Areas served include zip codes 92274.

We are a referral line, not a contractor. Calls are routed to independent local pros around Thermal who treat drying as a measured process with daily readings and written logs.
Low-grain refrigerant dehumidifiers pull moisture to levels standard units cannot reach. Desiccant units handle cold spaces and dense materials. Air movers are placed at specific angles to sweep moisture off wet surfaces.
Daily logs track humidity and material readings so drying decisions are based on data.
Each contractor runs an independent, licensed and insured business. Confirm both with the pro before equipment is set.
Drying is usually billed by equipment per day plus monitoring visits. You get the rates and an estimated number of days in writing.

The goal is simple: get every wet material back to the moisture level of similar dry materials in the house, and prove it with readings.

Pin and pinless meters plus an infrared camera show exactly where water traveled, including under cabinets, inside walls, and across the subfloor.
Sealing off the wet area with plastic focuses the equipment and shortens drying time.
Small holes behind baseboards let injection systems push dry air into wall cavities, which can avoid tearing out drywall that is otherwise sound.
Hardwood and subfloors are dried with mats and controlled airflow to reduce cupping.
Equipment stays until wet materials match dry standard readings. The final log becomes part of your insurance file.
Tell the dispatcher when the leak happened and what has been done so far.
The pro arrives with moisture meters, infrared camera, and drying gear.
The pro maps moisture, records dry standard from unaffected areas, calculates equipment needs, and gives you a written estimate.
Equipment runs with daily readings and adjustments until every material reaches dry standard, then it is removed and the log is handed over.
Closing up wet framing is how mold starts.
A week of box fans did nothing. The pro found wet framing with infrared and dried it properly in four days.
Laura F.Hidden wet framing after leakWall injection drying saved our drywall. Just a few small holes behind the baseboards.
Kevin Y.Wall cavity dryingThe daily drying logs were detailed and made the insurance claim straightforward.
Mariah S.Insurance drying documentationOur oak floor was cupping. They used floor mats and kept the drying slow and steady. The boards flattened back out.
Henry L.Hardwood floor drying

Most jobs take three to five days. Dense materials like hardwood, plaster, and concrete can take a week or longer.
Consumer equipment is too weak to dry framing quickly enough to prevent mold.
Dry standard is the normal moisture reading of the same type of material in an unaffected part of the home. Drying is complete when wet materials match it.
GPP is a measure of moisture in the air. Lower GPP means faster drying.
It is loud and warm. Closing off the drying area helps at night.
No. A Water Damage is a free referral service that connects you with independent, licensed and insured local contractors who perform the drying.

Calls from Thermal and zip codes such as 92274 are routed to structural drying pros working locally.
Nearby cities are listed below.
